Now your system is ready for the updates. Long press MENU to enter Yellow menu (LED will change yellow) Procedure for performing the Factory Reset: ALP novelty compared to the G9 is that not only the number of sensors is memorized but also the exact ports where they are connected for more security. That is why installer/customer decides when the system is ready to memorize the sensor state. Since an ALP set is powered on many times before it is actualy installed in the customer car (factory test, dealer test, garage installer test, customer test, etc.) there is no real „first“ power-on. Same as with the G9, the ALP system will memorize the number of connected sensors only when Restore Defaults options is activated. You can scroll up and down and check all the options available to you and when you are done just click the Save & Download button at the bottom and save setup file to your USB Memory Stick Please do not choose Unlimited unless you are testing your system. Laser Defense it set at 4 Seconds by default.
If you want laser defense you will need to select: PDC & LID and once you click that option a new menu will appear with all the advanced options. Scroll to the bottom and look for Advanced Options: Under Region Choose your region: For most of you this will be N/S America and immediately the basic setup menu will be displayed:
#NET RADAR ALP REVIEW UPDATE#
Go back to the ALP update site (The main home page) and this time under SETUP hit the enter button: Save the file UCSET.bin (Standard Controller) or UCSTHIFI.BIN + VOICEPCK.ALP (HiFi Controller) to the same USB Drive that you saved the CPU firmware to. If you have the HiFi Controller you will need to download the current UCSTHIFI.BIN file: (Purple Download Button) and choose either the Male or Female Voice Pack ( VOICEPCK.ALP)
Standard Controller: (Non HiFi) - you will need to download the current UCSET.bin file: (Green Download Button) Usually with Firmware updates there is a matching Control Set Firmware that will also need to be downloaded: The Control set (Either the Standard or HiFi) firmware is listed on the same page as the CPU Firmware and will look like the following: Save file to a Fat 16 or Fat 32 formatted USB Drive.
#NET RADAR ALP REVIEW SERIAL NUMBER#
On the next screen it will ask for your Serial Number, Enter Serial number of your CPU and hit the OK Button:Īfter you hit the OK button an Equation will appear asking a simple math problem to verify you are a human, Put the answer in the box and hit the Press To Download button: Update the firmware of your AL Priority - Go to Under Firmware Upgrade hit the enter button: If you would like to activate advanced functions of the AL Priority to give you warning for interference or defense from laser guns you will to take the following steps: The AL Priority was designed as a parking aid and once installed they are full fledged parking sensors out of the box. Once the initial firmware update is done you may switch to the Bluetooth and all future updates will work fine with only the Bluetooth module connected. You will not be able to update the CPU for the first update using the Bluetooth module. Once the unit is fully updated you can disconnect the Control Module and plug in your Bluetooth module and all will be good.
#NET RADAR ALP REVIEW INSTALL#
** IMPORTANT ** - If you plan to install your ALP using Bluetooth instead of the Control Module you still need to update the ALP using the following instructions with the Control Module connected.
0 kommentar(er)
